If you, or someone you know, love to draw, sketch, or build then continue to read and learn more about the 3D sculpting pen from Brookstone! I recently tried out a 3D drawing pen and I love it! My sculpting pen is from Brookstone and I received it as a gift (shout out to my boyfriend). It took me a bit of time to use it because the manual seemed vague but difficult at the same time. Although the pen seemed too complicated, I decided to see how it worked. With a few clicks of some of the buttons on the pen, I figured it out! First, plug the pen in. After plugging the pen in, you will have to wait for it to get up to the correct temperature. This usually doesn't take too long, for me it was approximately 3 minutes. Once the pen is set at the right temperature, make sure to be very careful of the tip as it is very hot by this point. Choose a color that you would like to use, load it into your pen by using the load button, and begin creating! Choose your speed for delicate details or filling in your creations quickly. It is a pretty nifty device! I have created keychains, bookmarks, figures, and more! You'll enjoy using this pen to make art while having fun. The box recommends 8 years and up, but honestly I would recommend at least 14+. Or have complete supervision. Setting the pen down could result in burning plastic or paper. And holding to close to the bottom could result in a burn. Even the website says adults only, so the packaging contradicts their website warning... As long as you are careful about these things, the pen is awesome! Have any of you all tried out 3D pens before? What did you think of them? Leave a comment below!
0 Comments
Leave a Reply. |
Bethany S.Hello, I hope you enjoy my blog and my random thoughts that come with each post! If you would like to know more about me, check out the About Me tab above! Categories
All
Products of the Moment!
|